Refer to the exhibit. The network administrator enters these commands into the R1 router: When the router prompts for an address or remote host name, what IP address should the administrator enter at the prompt?

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:2 mins read

Refer to the exhibit. The network administrator enters these commands into the R1 router: R1# copy running-config tftp Address or name of remote host [ ]? When the router prompts…

Continue ReadingRefer to the exhibit. The network administrator enters these commands into the R1 router: When the router prompts for an address or remote host name, what IP address should the administrator enter at the prompt?

Refer to the exhibit. Which two statements are correct based on the output as shown in the exhibit? (Choose two.)

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:2 mins read

Refer to the exhibit. Which two statements are correct based on the output as shown in the exhibit? (Choose two.) The output is the result of the show ip nat…

Continue ReadingRefer to the exhibit. Which two statements are correct based on the output as shown in the exhibit? (Choose two.)

Based on the configuration and the output shown, what can be determined about the NAT status within the organization?

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:2 mins read

Refer to the exhibit. The NAT configuration applied to the router is as follows: ERtr(config)# access-list 1 permit 10.0.0.0 0.255.255.255 ERtr(config)# ip nat pool corp 209.165.201.6 209.165.201.30 netmask 255.255.255.224 ERtr(config)#…

Continue ReadingBased on the configuration and the output shown, what can be determined about the NAT status within the organization?

Refer to the exhibit. The student on the H1 computer continues to launch an extended ping with expanded packets at the student on the H2 computer. The school network administrator wants to stop this behavior, but still allow both students access to web-based computer assignments. What would be the best plan for the network administrator?

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:2 mins read

Refer to the exhibit. The student on the H1 computer continues to launch an extended ping with expanded packets at the student on the H2 computer. The school network administrator…

Continue ReadingRefer to the exhibit. The student on the H1 computer continues to launch an extended ping with expanded packets at the student on the H2 computer. The school network administrator wants to stop this behavior, but still allow both students access to web-based computer assignments. What would be the best plan for the network administrator?

Refer to the exhibit. Which two ACLs would permit only the two LAN networks attached to R1 to access the network that connects to R2 G0/1 interface? (Choose two.)

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:2 mins read

Refer to the exhibit. Which two ACLs would permit only the two LAN networks attached to R1 to access the network that connects to R2 G0/1 interface? (Choose two.) access-list…

Continue ReadingRefer to the exhibit. Which two ACLs would permit only the two LAN networks attached to R1 to access the network that connects to R2 G0/1 interface? (Choose two.)

What is the recommended Cisco best practice for configuring an OSPF-enabled router so that each router can be easily identified when troubleshooting routing issues?

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:2 mins read

What is the recommended Cisco best practice for configuring an OSPF-enabled router so that each router can be easily identified when troubleshooting routing issues? Use the highest IP address assigned…

Continue ReadingWhat is the recommended Cisco best practice for configuring an OSPF-enabled router so that each router can be easily identified when troubleshooting routing issues?

Refer to the exhibit. This network has two connections to the ISP, one via router C and one via router B. The serial link between router A and router C supports EIGRP and is the primary link to the Internet. If the primary link fails, the administrator needs a floating static route that avoids recursive route lookups and any potential next-hop issues caused by the multiaccess nature of the Ethernet segment with router B. What should the administrator configure?

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:3 mins read

Refer to the exhibit. This network has two connections to the ISP, one via router C and one via router B. The serial link between router A and router C…

Continue ReadingRefer to the exhibit. This network has two connections to the ISP, one via router C and one via router B. The serial link between router A and router C supports EIGRP and is the primary link to the Internet. If the primary link fails, the administrator needs a floating static route that avoids recursive route lookups and any potential next-hop issues caused by the multiaccess nature of the Ethernet segment with router B. What should the administrator configure?

On which two routers would a default static route be configured? (Choose two.)

  • Post author:
  • Post category:SEO
  • Post comments:0 Comments
  • Post last modified:March 5, 2024
  • Reading time:2 mins read

On which two routers would a default static route be configured? (Choose two.) stub router connection to the rest of the corporate or campus network any router where a backup…

Continue ReadingOn which two routers would a default static route be configured? (Choose two.)